|
Concealed Fastener Flashing Profiles
Below are common profiles of concealed fastener
flashings. Click on an item to advance to the ordering page for that
profile. For those requiring supplemental flashings (ie, clip, Z's), they
can be ordered from the same page as the flashing itself. |
|
|
Fascia Trim |
 Supplemental Flashings:
Fascia Clip
Applied as
trim to fascia board and/or blocking. An open hem on the bottom allows for
clip
|
|
|
Rake Trim |
 Supplemental Flashings:
Rake Clip
Installed as
trim to cover rake board, with an extended leg to cover over metal roofing
ribs.
|
|
|
Eave Trim |
Supplemental Flashings: Gutter (If applicable)
Installed on
the edge of roofing as a base for concealed roofing panels and fixture for
gutter installation.
|
|
|
Ridge Cap |
Supplemental Flashings: Z-Metal
Installed as
flashing for the peak/ridge of a roof. Open hems at the edges clip onto
Z-Metal (Z's) placed between each panel.
|
|
|
Roof to
Wall |
 Supplemental
Flashings: Z-Metal
Transitional
flashing from a wall to the upper part of the roof. the open hem on the
bottom is attached to Z-Metal (Z's) placed between each panel.
|
|
|
Sidewall |
 Transitional flashing
that attaches to the wall (similar to a rake) and extends out and over
roofing panel ribs. |
|
|
Base
Flashing |
Supplemental Flashings: Clip (If applicable)
Installed as a
waterproofing element at the base of concrete foundations and other
similarities, base flashing is a common, yet necessary component. |
|
|
Cap Metal |
 Supplemental
Flashings: Clip
Sheet metal
cap with a drip edge, that can be used to flash out walls, parapets, and
more. |
|
|
Z Metal |
 Installed between metal
roofing panels as a supplement to other flashings like roof to wall and
ridge cap, Z's can be ordered and cut to the width of your panels. |
|
|
J Metal |
 Used most often in the
installation of wall panels, J metal has a variety of other uses. This
common profile allows for easy customization to your own needs. |
|
|
Inside
Corner |
 This flashing is
applied to the inside corners of walls where sheet metal wall panels are
installed. Closed hems at the end provide a clean and professional look. |
|
|
Outside
Corner |
 Similar to inside
corner (above), this type of flashing is installed at the outside corners of
walls with sheet metal panels. |
|
|
Return
to Online Ordering Homepage |
|
|
|
|
